บริษัท อี แอนด์ เอ็ม (ไทยแลนด์) จำกัด
ASCO PUMP EPI
The EPI centrifugal pump is suitable for handling water or similar liquids mainly used in the following
Application
-Water
-Industry
-Mining
-Environmental
Operating Data --50Hz
-Pump sizes up to 25mm to 350mm
-Flow up to 540 L/s
-Head up to 160 m
-Temperature up to 120C
-Speed up to 3600 rpm
-Pressure up to 24Bar
Construction
Horizontal single stage, end suction with vertical discharge. The "back pull out" design allows for the maintenance of the pump without disturbing the pipework connected to the casing, or the pump alignment. The pump is built to the dimensional requirements of ISO 2858, Flanges are in accordance with EN 1092.
Casing
Self-venting horizontal volute casing with horizontal end suction and vertical discharge. The suctionnozzle has a vane to reduce prerotation.
Shaft
Tapered & keyed shaft design allowing ease of removal in maintenance & positive locking whilst in operation.
Pump Selection
For pump selection the hydraulic performance curves should be used. These curves are based on water at 15 C and SG equal to 1. 0. NPSH values are indicated on the performance curves. At least 0.5m should be added as a safety margin To overcome variations between actual and design requirements it is recommended that the driver power exceeds the absorbed pump shaft power.
Bearing housing
Robust / heavy duty, manufactured in high strength cast iron providing trouble-free life complete with lifting provision and support foot.
Shaft seal
Single, high quality mechanical seal fitted as standard to all pumps. Different seals are possible on application.